Uninstalling/reinstalling blender on all nodes + master and re-enabling the CR plugin prompted a firewall warning from Windows which I had to accept. All is working now!
Hey @James Crowther I've been away from Blender for a while. Just now got around to upgrading to 025 on all my devices. Getting a constant "sync failed" I've tried completely removing CR from all devices and installing fresh. Connection and "ready" mode works. {"time_logged": 1586454848, "time_stamp": "Thu Apr 9 13:54:08 2020", "message": "Info: node status updated: syncing...", "level": 6}
Ok, one thing you can try, with CR enabled, and your computers connected via the CR panel, simply save the current file, then re-open it by going to blender -> File -> Open and simply open the file you are currently working on.
This may sound a little odd, but this normally clears the fault.
If that doesn't work, then try the following:
With your other computer connected in CR, press the "resync" button. This will upload the blend file again. If you still see sync failed after this. Once more, go to Blender -> File -> Open and re-open the same file. This should clear even the most stubborn of sync failures :)
None of these steps were working for me.
Uninstalling/reinstalling blender on all nodes + master and re-enabling the CR plugin prompted a firewall warning from Windows which I had to accept. All is working now!
Hey @James Crowther I've been away from Blender for a while. Just now got around to upgrading to 025 on all my devices. Getting a constant "sync failed" I've tried completely removing CR from all devices and installing fresh. Connection and "ready" mode works. {"time_logged": 1586454848, "time_stamp": "Thu Apr 9 13:54:08 2020", "message": "Info: node status updated: syncing...", "level": 6}
{"time_logged": 1586454849, "time_stamp": "Thu Apr 9 13:54:09 2020", "message": "Info: node status updated: sync failed", "level": 6}
{"time_logged": 1586454849, "time_stamp": "Thu Apr 9 13:54:09 2020", "message": "Info: node status updated: repairing...", "level": 6}
{"time_logged": 1586454849, "time_stamp": "Thu Apr 9 13:54:09 2020", "message": "Info: node status updated: sync failed", "level": 6}
Hi there Mr Burns :)
Ok, one thing you can try, with CR enabled, and your computers connected via the CR panel, simply save the current file, then re-open it by going to blender -> File -> Open and simply open the file you are currently working on.
This may sound a little odd, but this normally clears the fault.
If that doesn't work, then try the following:
With your other computer connected in CR, press the "resync" button. This will upload the blend file again. If you still see sync failed after this. Once more, go to Blender -> File -> Open and re-open the same file. This should clear even the most stubborn of sync failures :)
Let me know if this helps at all!
James