I use CR in local network.
Both machines are Linux and everything works just fine.
My only problem is: when I close Blender and turn it on again, all settings are gone. I have to add my seccond machine, set up which devices should be used and so on..
Is there any way to keep those settings? So each time I start Blender I have all the machines with proper devices and correct load balance set up?
Hi there!
Load balancing is saved
Nodes are saved.
Compute devices are NOT saved - have to manually turn off CPU for each node when GPU computation is ON.
I don't know if it's a good behavior, but it needs me to press "Connect" and confirm IP address for remote node. It does not sync by itself. Not a big problem - just mentioning.